Just a thought and this thought not approved by PLM World, Darth Vader nor the masters of the straitjacketed public face of Siemens. Perhaps the lack of starch and suit jackets in our haberdashery and attitudes just might be a good thing for the whole BBS and Community sites to embrace if they want lots of readers. Perhaps the SE guys should be dictating what goes on there since clearly the SE users are the most active. I wonder if any of the mucky mucks in PR and Marketing have noticed that the guys that don’t wear suits, that be you SE users by the way, also have the largest number of posts BY FAR in SE Misc over any other category. I have asked that they open it up for us to be read only but no reply to that idea as of today.Īs an aside here and speaking of forums and the Siemens BBS.
I understand that they may not want us posting over there but the CAM problems that those guys run into will be the ones we will also run into I would think. It is my hope that Geometric would open up the CW4BX (Camworks for Brand X 😉 ) forum to CW4SE users though. There is a lot of similarity between CW4SE and CW for Brand X though. They are falling down on the job here sad to say. Geometric was supposed to be looking into a forum for CW4SE users but as of today no forum and darned few videos either. There is not a whole lot of information out there yet and looking through YouTube videos and online searching does not reveal much. We all look for information that can be used to our benefit and of course I have been searching for info on CAMWorks for Solid Edge (CW4SE).
0 kommentar(er)
